Qsc-audio DSP-30 Bedienungsanleitung PDF herunterladen (Seite 6)

Support the Rear for Portable/Mobile Installations

If the DSP-30 is to be transported while in a rack, we recommend supporting the rear of the chassis. This will help

prevent the unit from being damaged from the increased mechanical stresses of portable and mobile use. The DSP-

30’s chassis includes integral rear mounting tabs for securing to the rack mounting ears.

Installation: Unpacking and Mounting

Unpacking

The DSP-30 can be used in or out of an equipment rack. Adhesive rubber feet are included for non-rack mount installations.

Use them to prevent the unit from scratching or marring support surfaces.

What is included in the carton:

Item Description Quantity

1- DSP-30 Digital Signal Processor 1

2- Self-adhesive rubber feet 4

3- Hardware Manual (this document) 1

4- Signal Manager Software CD 1

5- IEC Power Cord 3 x #18 AWG 1

6- RS-232 cable (6 ft.) 1

Rack mount the DSP-30 by support-

ing it from underneath while align-

ing the mounting holes with the

threaded screw holes in the rails;

install all four mounting screws and

washers and tighten securely. Ensure

use of all four mounting screws in

order to minimize the chance of

bending or distorting the rack mount

ears. Rack mounting is optional.

Rack Mounting

Mounting

There are no special unpacking precautions. However, it is recommended you keep the original packing material for reuse

in the rare event that service be required. If service is required and the original packing material is not available, ensure

that the unit is adequately protected for shipment (strong box of appropriate size , sufficient packing material to prevent

load-shifting or impact damage).

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Keine Kommentare

Qsc-audio DSP-30 Bedienungsanleitung Seite 6